DESIGN
Installation of wall panels is based on the “C” studs of width 75 mm or 100mm, made of high quality galvanized steel 1,5mm. The studs are levelled using the adjusting screw. The lower “U” profile, made of high quality galvanized steel 1,5 mm is base for plinth – curved connection of wall and floor, it is mounted to the floor with galvanized anchor. The upper “U” profile is closing the system.
The “C” studs have the special openings to hang the wall panels on the hooks, with maximum joint width of 3 mm sealed by the special gasket.
All internal corner wall panels are curved and easy to clean.
The partition wall system design facilitates the dismantling of any individual panel, to provide easy access for later installations, alterations or repair work.

SURFACES

  • Stainless steel (grade AISI 304 or 316),polished or powder coated with antibacterial paint
  • Galvanized steel, powder coated with antibacterial paint
  • Glass fixed on steel frame, available with decorative photos

TECHNICAL DATA
Heat resistance:

  • double-layered wall panel: 1,75 m2*K/W
  • single-layered wall panel: 1,60 m2*K/W

Sound insulation:

  • double-layered wall panel: Rw(C;Ctr) =57 (-4, -12) dB

Air permeability:

  • 0,3 m3/hm2 (hypertension and hypotension 500 Pa)
SURFACES
  • Stainless steel (grade AISI 304 or 316),polished or powder coated with antibacterial paint
  • Galvanized steel, powder coated with antibacterial paint
  • Glass fixed on steel frame, available with decorative photos
Air permeability:
  • 0,3 m3/hm2 (hypertension and hypotension 500 Pa)
TECHNICAL DATA
Heat resistance:
  • double-layered wall panel: 1,75 m2*K/W
  • single-layered wall panel: 1,60 m2*K/W
Sound insulation:
  • double-layered wall panel: Rw(C;Ctr) =57 (-4, -12) dB

DESIGN

Installation of wall panels is based on the “C” studs of width 75 mm or 100mm, made of high quality galvanized steel 1,5mm. The studs are levelled using the adjusting screw. The lower “U” profile, made of high quality galvanized steel 1,5 mm is base for plinth – curved connection of wall and floor, it is mounted to the floor with galvanized anchor. The upper “U” profile is closing the system.
The “C” studs have the special openings to hang the wall panels on the hooks, with maximum joint width of 3 mm sealed by the special gasket.
All internal corner wall panels are curved and easy to clean.
The partition wall system design facilitates the dismantling of any individual panel, to provide easy access for later installations, alterations or repair work.

SURFACES
  • Stainless steel (grade AISI 304 or 316),polished or powder coated with antibacterial paint
  • Galvanized steel, powder coated with antibacterial paint
  • Glass fixed on steel frame, available with decorative photos
TECHNICAL DATA Heat resistance:
  • double-layered wall panel: 1,75 m2*K/W
  • single-layered wall panel: 1,60 m2*K/W
Sound insulation:
  • double-layered wall panel: Rw(C;Ctr) =57 (-4, -12) dB
Air permeability:
  • 0,3 m3/hm2 (hypertension and hypotension 500 Pa)
  1. Clamping profile
  2. Cross connector

  3. Ceiling panel

  4. Nonius hanger-upper

  5. Nonius hanger-lower

  6. Peripheral light